|
|
|
|
|
System II:
Our System II door
opener will release and open a locked door, pause for
entrance or exit, close automatically, and then return the
door to its locked position. If you would like to extend
the time the door is open, you can do so by pushing the
remote control again. The door will stay open as long as
you like. To close the door, simply push the remote once
again.
For extra security, System II can work with an optional
deadbolt function along with the normally included
electric strike plate door latch release mechanism. |
Specifications - Door Operator Model 100
(NOTE: Model 200
is identical except the electromechanical clutch is replaced
by a
non-electrical slipping clutch. Mostly for commercial use.)
Automatic door operator shall be electromechanical, and
provide for both powered opening and powered closing of
a door. The door opener shall provide no influence upon
the door except when it is actively involved with
powered opening, holding open, or closing, thus allowing
unencumbered manual operation.
The unit shall contain an internal battery power supply
to provide powered operation in the event of external
power failure. The unit shall be powered by 24 vac,
external to the device under provisions of low voltage
wiring and is supplied with a 40 VA transformer
requiring 115 vac 60 Hz service.
The operator shall be mounted according to drawings and
instructions provided with each unit. The unit shall be
capable of mounting on either door or lintel and shall
provide door opening angles up to 180 degrees.
The unit shall possess an adjustable hold-open feature
allowing the door between 5 and 60 seconds for passage.
The unit shall stop when encountering an obstruction
during an operating cycle at which time it ceases to
provide an influence on the door.
Operation
Electro-mechanical. Power open, power close.
Automatic clutch disengagement at all times when not
activated, allowing unimpeded manual operation.
|
Automatic open-hold-close cycle (5 to 60 seconds)
activated by a signal from internal radio receiver or
the momentary closure of electrical contacts provided by
wires to unit.
Automatic cycle may be interrupted by a signal received
within the cycle bringing the operator into a disengaged
state. Door may be closed remotely if door is found left
open in a non-active state upon receipt of a signal.
Optional Mode (Auto-Close setting) - Causes door to
close automatically after a delay upon manual opening.
Can be brought into activation in one of three ways:
1. Provision of electrical wires to unit to provide a
discontinuity between internal contacts.
2. Provision of discontinuity of contacts upon
installation.
3. Removal of 24 vac external power to operator.
Electrical
Specifications
Operator:
16-24 vac/dc, 0.01 amp
Wall Transformer:
Input - 115 vac, 60 Hz
Output - 24 vac, 0.03 amp
Battery:
12V DC, 1.2Ah lead acid gel cell
Motor:
12V DC, 1.5A
Clutch:
12V DC, 0.5A
|
Supply for Unlatching Device:
12V DC, 1A
Radio Receiver:
19,683 Security Combinations (Programmable)
Dimensions:
2 5/8” x 14 1/8” (Suitable for mounting with
perpendicular wall close to door frame.)
Weight:
10 Lbs.
Material/Finish:
Steel housing
Painted aluminum finish #25
Physical Applications:
Door mounted for inward and outward opening
doors in either right-hand or left-hand hinged
configurations. (Ceiling clearance 1 1/4” minimum
between door and ceiling).
Lintel mounted for inward and outward opening doors in
either right-hand or left-hand hinged configurations.
Activation
Activation may occur by
coded signal from transmitter or by wireless security
entry system. Activation contacts are provided within
unit for remote wired activation from any device
providing momentary continuity such as touch
plates, push plates,
mats, or infrared motion sensors.
________________________
Warranty
Open Sesame Operators
and controls are covered by a one year limited warranty
on materials and internal workmanship. Our warranty does
not apply to services performed during installation but
technical assistance is available.
________________________ |
This package will
release and open a locked (or unlocked) door, pause for
entrance or exit, close automatically, and then return the
door to its locked position. If you would like to extend the
time the door is open, you can do so by pushing the remote
control again. The door will stay open as long as you like. To
close the door, simply push the remote once again. Leaves the
door free-swinging for manual use.
Important note: Our
product is not recommended for use with doors that are
typically manufactured by window companies with proprietary
3-point locking systems, which have upper and lower latches
(or pins) as well as a latch on the side. There is no way to
electrically release the upper and lower latches to allow the
door to open automatically. Also, the latch on the side of the
door may not be a standard type latch, it may be a deadbolt
type latch or it may be a latch of some proprietary
size/shape. The entire door handle set and latches may have to
be removed and replaced with a standard locking door handle
and latch. Additionally, these kind of doors may have very
heavy door seals or weather stripping, that requires a lot
more force than usual to open or close. This may require
experimentation with regard to the door operator and arm
mounting positions in order to overcome the resistance of the
tight seals
Package Includes
.jpg) |
Opener |
 |
Electric Strike |
 |
Remote |
 |
Power Supply |
|
Open Sesame System II |
|
>>> Free
Shipping On All Automatic Door Openers <<<
|
|
