|
Automatic door operator shall be electromechanical, and
provide for both powered opening and powered closing of
a door. The door opener shall provide a small resistance
when a person push's the door open then will slowly
close behind the person just like every other commercial
door.
Can be used
in light commercial applications, such as school doors,
restroom doors, apartment lobby doors, storefronts,
elevators/lifts, or
residential
or pedestrian gates. When triggered via our remote
controls they go through an open-pause-close cycle. The
operator will
close
automatically against manual opening of the door, like a
standard door closer. NOTE: Any existing door closer
must be removed
or disabled.
Includes Model 200 operator, two rugged wireless wall
push
pads, and wiring kit with transformer. Does not include
an electric
strike
plate
The unit shall contain an internal battery power supply
to provide powered operation in the event of external
power failure. The unit shall be powered by 24 vac,
external to the device under provisions of low voltage
wiring and is supplied with a 40 VA transformer
requiring 115 vac 60 Hz service.
The operator shall be mounted according to drawings and
instructions provided with each unit. The unit shall be
capable of mounting on either door or lintel and shall
provide door opening angles up to 180 degrees.
The unit shall possess an adjustable hold-open feature
allowing the door between 5 and 60 seconds for passage.
The unit shall stop when encountering an obstruction
during an operating cycle at which time it ceases to
provide an influence on the door.
Operation
Electro-mechanical. Power open, power close.
Automatic clutch disengagement at all times when not
activated, allowing unimpeded manual operation.
|
|
Automatic open-hold-close cycle (5 to 60 seconds)
activated by a signal from internal radio receiver or
the momentary closure of electrical contacts provided by
wires to unit.
Automatic cycle may be interrupted by a signal received
within the cycle bringing the operator into a disengaged
state. Door may be closed remotely if door is found left
open in a non-active state upon receipt of a signal.
Optional Mode (Auto-Close setting) - Causes door to
close automatically after a delay upon manual opening.
Can be brought into activation in one of three ways:
1. Provision of electrical wires to unit to provide a
discontinuity between internal contacts.
2. Provision of discontinuity of contacts upon
installation.
3. Removal of 24 vac external power to operator.
Electrical
Specifications
Operator:
16-24 vac/dc, 0.01 amp
Wall Transformer:
Input - 115 vac, 60 Hz
Output - 24 vac, 0.03 amp
Battery:
12V DC, 1.2Ah lead acid gel cell
Motor:
12V DC, 1.5A
Clutch:
12V DC, 0.5A
|
Supply for Unlatching Device:
12V DC, 1A
Radio Receiver:
19,683 Security Combinations (Programmable)
Dimensions:
2 5/8” x 14 1/8” (Suitable for mounting with
perpendicular wall close to door frame.)
Weight:
10 Lbs.
Material/Finish:
Steel housing
Painted aluminum finish #25
Physical Applications:
Door mounted for inward and outward opening
doors in either right-hand or left-hand hinged
configurations. (Ceiling clearance 1 1/4” minimum
between door and ceiling). Lintel mounted for inward and
outward opening doors in either right-hand or left-hand
hinged configurations.
Activation
Activation may occur by
coded signal from transmitter or by wireless security
entry system. Activation contacts are provided within
unit for remote wired activation from any device
providing momentary continuity such as touch
plates, push plates,
mats, or infrared motion sensors.
________________________
Warranty
Open Sesame Operators
and controls are covered by a one year limited warranty
on materials and internal workmanship. Our warranty does
not apply to services performed during installation but
technical assistance is available.
________________________ |
